I had created a handful number of applications last week with the business capabilities, but the default report that Lean IX provides the application landscape report. It is not reflecting those applications in it’s report. Is there any place where I have to update?
Solved
The application landscape reports is not reflecting some of the applications that was created recently
Best answer by Carsten
Hello
this sounds like a filtering problem, usually the quality seal filer is often set by default:
So if you see this filter, you should check if the new applications are not on status draft. You can approve them. Or you can remove the filter, by clicking on the ‘x’ .
Sometimes there are other filters used, e.g. Lifecyle etc.
A screenshot will help for deeper analysis.
Best regards,
Carsten
+1Hello
this sounds like a filtering problem, usually the quality seal filer is often set by default:
So if you see this filter, you should check if the new applications are not on status draft. You can approve them. Or you can remove the filter, by clicking on the ‘x’ .
Sometimes there are other filters used, e.g. Lifecyle etc.
A screenshot will help for deeper analysis.
Best regards,
Carsten
Carsten Schubert
Login to the community
No account yet? Create an account
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.